favorite
favorite
hide
unhide
flag

Posted

print

Alessandro... Guru Amp Builder... - $800 (Sunbury)

Alessandro... Guru Amp Builder... 1 thumbnailAlessandro... Guru Amp Builder... 2 thumbnailAlessandro... Guru Amp Builder... 3 thumbnailAlessandro... Guru Amp Builder... 4 thumbnailAlessandro... Guru Amp Builder... 5 thumbnailAlessandro... Guru Amp Builder... 6 thumbnailAlessandro... Guru Amp Builder... 7 thumbnailAlessandro... Guru Amp Builder... 8 thumbnailAlessandro... Guru Amp Builder... 9 thumbnailAlessandro... Guru Amp Builder... 10 thumbnail
The Boxer Working Dog, by amp Guru George Alessandro, is a hand-wired point-to-point ( NO PCBs in the Amp) 20-watt 2X10 guitar amplifier... The preamp section consists of one 12AT7 reverb tube, two 12AX7 pre-amp and phase-inverter tubes, with two 6V6s in the power section (JJs)...one channel. It has two 10"Jensen Special Design speakers. It has a Final Output Control (think master volume) which can cut the power by 50%. Also there is a toggle to alter the sound from Creamy to Jangly. Reverb is onboard. Three band EQ. Very nice condition. It was just gone over and serviced by Abell Audio (8/16/23). The weight is approximately 38lbs.

Handwired with top shelf components. Check out the online reviews
Here is an article about Guru builder George Alessandro. He has built lots of amps for lots of "stars": https://www.premierguitar.com/gear/builder-profile/amp-guru-george-alessandro

•Hand-wired / hand-assembled for years of service
•High-strength stainless steel chassis and overbuilt for extreme roadworthiness
•Ceramic tube sockets with silver-plated military-spec contacts
•Teflon with silver wiring utilized throughout
•Variable fixed bias for ease of servicing
•Silver-plated military spec input jack
•High-reliability circuit design for longer tube life
•Audiophile-grade silver solder used throughout for the utmost in signal transfer
•Precision matched/balanced phase-inverter circuit incorporates a 360-degree, phase-transparent pre-amp circuit."

Note: The Working Dog Badge is not attached (shown in the second picture) but included.

Price is $800 cash....


The control layout consists of:

Reverb
Final Output Control
Volume
Treble
Middle
Bass
Jangly/Creamy switch
Stand-by switch and
On/Off switch

post id: 7760210992

posted:

updated:

best of [?]

loading
reading
writing
saving
searching