favorite
favorite
hide
unhide
flag

Posted

print

SWR Silverado Special - $450 (Gahanna)

12345678910
Excellent condition with casters, and heavy padded Tuki cover. Cash only, no trades.

SPECS:

Silverado Special
ELECTRONIC SPECIFICATIONS
Note:All measurements were taken with a line voltage of 120 VAC
All noise specifications are "unweighted."
All voltages and watts are "RMS."
All measurements taken with tone controls set flat, Aural Enhancer at minimum
POWER (minimum)
350 Watts @ 4 Ohms
450 Watts @ 2 Ohms
Note: Internal speaker impedance is 4 ohms.
FREQUENCY RESPONSE (Power Amplifier): -3dB @ 20Hz and 40KHz
SENSITIVITY *(full output under clipping, 8 ohms load, 100 Hz)
Passive Input Jack: 38 millivolts
Active Input Jack: 160 millivolts
Power Amplifier (Effects Return Jack "in"): 1.5 volts
*With limiter circuit defeated.
INPUT IMPEDANCE
Passive/Active Input: 800K Ohms
Active Input: 60K Ohms
Effects Return: 27K Ohms
OUTPUT IMPEDANCE
Effects Send: 100 Ohms
Tuner Send: 100 Ohms
XLR Balanced Out: 750 Ohms
SIGNAL TO NOISE RATIO: -72 dB (<10 millivolts typical)
EQUIVALENT INPUT NOISE: 9 microvolts
WEIGHT: 90 lbs.
SIZE: 22.5"W x 28"H x 18"D
SPEAKER ENCLOSURE SPECIFICATIONS
POWER HANDLING: 500 watts RMS
IMPEDANCE: 4 Ohms
SPEAKER COMPLIMENT
Two 12" custom-designed SWR drivers
One Foster Horn
Front Ported Enclosure
GENERAL INFORMATION AND DESCRIPTION
The Silverado Special Integrated Bass System from SWR Sound Corporation was designed for the player who prefers a
straightforward, no-frills preamp combined with a power amp and speaker system capable of delivering enough power and
headroom for most live applications.
The Silverado Special maintains the same quality components and materials found in all SWR products and is assembled
by hand at our factory in Sun Valley, California.
The two preamp gain stages utilize a specially selected 12AX7 preamp tube. The tone controls incorporate I.C.'s and the
power amp is designed with very high quality bi-polar devices. Each type of device was chosen for its performance and
reliability in the application used. Aluminum is used for the chassis because of its good electrical and thermal
characteristics and is much lighter than commonly used cold rolled steel. All primary electrical components are U.L.
approved and we use Beldon Cable for all shielded wire.
The speaker cabinet is constructed of 5/8" plywood and uses interlocking dado and rabbet joints with heavy duty internal
bracing. The speaker configuration features two SWR 12" speakers and an inductive type Piezo tweeter.
Everybody at SWR sincerely hopes that the purchase of our product adds to the enjoyment of your playing and that it lives
up to all your expectations and more!

  • do NOT contact me with unsolicited services or offers

post id: 6972821695

posted:

updated:

best of [?]